产品介绍       |       联系我们       |       公司简介




产品搜索
   
 





 产品介绍-》慕湖产品


2070 高强聚合物外墙腻子胶(双组份)
Polymer External Wall Putty(Two component)

  强度高,耐水、耐碱性和耐冻融稳定性优良。与墙体和各种外墙涂料粘结力强。
   采用高性能聚合物树脂,抗裂性高,具有良好的防水功能。
   彻底改变在传统配制外墙腻子过程中,选用材料及配比随意性大、强度低、耐水耐碱性差等重大缺陷,并且省工省力,使用更方便。

一、应用范围:
  
广泛应用于各种建筑物外墙水泥砂浆、混凝土、 TK 板、石膏板、珍珠岩、加气混凝土砌块等表面批嵌,为外墙装饰面提供平整、完好和坚实的理想基层,从而极大提高建筑物外墙的装饰效果和外墙涂料的使用寿命。

Scope of Application
  
It is widely used as a primer on external wall of various buildings including the walls made from cement mortar , concrete , TK board , gypsum board , pearlier board , aerated concrete block etc . providing flat , smooth and strong substrate for finishing of the external wall . The decorative effect of the wall finish can be greatly enhanced and service life of the exterior coating can be extended .

二、技术标准: Technical Specification

项目( Item )

指标

施工性

Application property

刮涂无障碍,易打磨

Easy to apply with no obstacle, easy to be sanded

干燥时间(表干)

Dry time (surface dry) h

< 5

耐水性( 48h )

Water resistance ( 48h )

无易常

No abnormal phenomenon

耐碱性

Alkali resistance ( 24h )

无易常

No abnormal phenomenon

粘结强度、标准状态

Bonding strength standard state MPa

> 1.0

耐冻融性

Freeze-thaw resistance(10 cycles)

不起泡、不剥落、无裂纹、无明显变化

No blisters, no peeling, no cracks, no notable change

初期干燥抗裂性

Early crack resistance upon drying

不出现裂纹

No cracks appearing

三、使用方法:
  
1 、将甲组份胶料与乙组份粉料按 l : 2.5 重最比混合,并充分搅拌成均匀胶料即可使用,并在 6 小时内用完。
   2 、刮涂法施工,干后 ( 一般为 3 ~ 4 小时 ) 应立即打磨。否则时间过长,腻子胶硬化将导致打磨困难。通常刮涂腻子胶三天后方可涂刷各种外墙涂料。

四、理论涂布量:
  
平整墙面每公斤腻子胶可批刮约 1 平方米 左右 ( 二遍 ) 。

五、包装规格:
  
甲组份胶粘采用 5 0 ㎏ 塑桶包装。乙组份粉料采用 2 5 ㎏ 复合纸袋包装。保质期:在 0~ 4 0 ℃ 库房内储存,保质期为一年。

六、注意事项
  
1 、新粉水泥堵耐,冬天需养护 20 天以上,夏天需养护 10 天以上方可进行外墙腻子胶的批刮施工。  2 、产品在运输、储存过程中应严格防雨防潮,施工温度不得低于 5 ℃ 。

 Features of Performance
  
High strength , excellent water , alkali and freeze-thaw resistance . High adhesion to surface of various walls and exterior coatings
   It has good waterproof property , high crack resistance because imported hydrophobic polymer is incorporated in the formulation .
   The disadvantage of using traditional primer . such as random selection of materials and mixing ratio , low strength and poor water , alkali resistance , can be overcome . Moreover , workload and labor are saved , application is easier .

Application Instruction
  
Mixing ratio : Liquid Putty : Putty Powder=1 : 2.5 . Before application they must be stirred evenly first , the paste should be used up within 6 hours .
   Adopts scraping method . Polish immediately after the layer is dry completely(approx . 3-4 hours) , otherwise the putt), glue will be indurations cause smooth difficulty . Usually the external wall paint can be brushed after three days .

Theoretical Application Rate
  
1 m 2 /kg if the wall surface is fiat(two lays) .

Package
  
Liquid putty 5 0 ㎏ , plastic barrel .
   Putty powder 2 5 ㎏ , laminated paper bag .

Quality Guarantee Period
  
12 Months if stored in warehouse under the condition of 0~ 40 ℃ .

Notice
  
New cement screed wall should be cured for more than 20 days in winter and more than 10 days in summer before application of the primer
   The product should be protected against rain and moisture . Application temperature should not be lower than 5 ℃ .

Safety and Health
  
This product is environment — friendly product . It does not contain formaldehyde , halide or aromatic hydrocarbon and heavy metal such as lead , mercury , cadmium etc . at a11 . It is safe and nontoxic . Therefore it is non-hazardous goods.


北京慕湖外加剂有限公司 版权所有
Copyright©2001 Beijing Muhu Concrete Admixture Co.,Ltd.
设计制作:
中国建材电子商务网